► Selective bed width:
S series: 300mm
M series: 350mm
L series: 400mm
► Varied spindle bore diameters:
S series: Ø58mm / Ø80mm(Optional)
M series: Ø85mm/ Ø105mm(Optional)
L series: Ø85mm / Ø120mm(Optional)
► With FAG or SKF precision bearings installed on spindle,maximum cutting depth can be 8mm
on 50mm diameter and best roundness reaching 0.003mm (200mm long).
► Equipped with plastic rear gears, shafts and gears inside headstock are well protected
if crash should occur. (Opt. S430 & S480 Series)
► Thermal treated and precision ground alloy gears.
► Universal gearbox for both imperial and metric threading – conversion table also attached.
► Tracks of cross slide and bed are well lubricated with lubrication pump (manual).
► Overload device to ensure safely when operating.
► Wear-resistant phosphor bronze lead screw nuts.
► Durable reservoir oil bath type cross slide. (for S series)
► Thermal treated Meehanite casting bed, hardness of bed reaching HS70.
► One-piece base with high rigidity and low vibration.
► High-capacity coolant tank offers sufficient coolant output.
► Plastic gear on the rear side of headstock. (Opt. S430 & S480 Series)
► Reservoir Oil Both Type Cross Slide ( for S Series)
► Bearings on the spindle are imported from Germany.
Varied spindle bore diameters:
S series:Ø58mm & Ø80mm(Opt.)
M series:Ø85mm & Ø105mm(Opt.)
L series:Ø85mm & Ø120mm(Opt.)